Strathcona County - Interactive Land Use Bylaw
Part 8 : Commercial Zones
8.4 C4 – Major Commercial
Purpose
To provide a diversity of commercial and compatible uses in accessible locations within the Urban Service Area.
Uses
Subject to any fundamental use criteria for certain uses set out below, the permitted uses and the discretionary uses for this zone are listed in Table 8.4(A).
Table 8.4(A) Permitted and Discretionary Uses
* Refer to Part 6: Specific Use Regulations for additional regulations pertaining to this use.
^ Refer to Section 13.2 IHO 1.5 – Heavy Industrial Transition Overlay 0 km to 1.5 km and Section 13.3 IHO 3.0 – Heavy Industrial Transition Overlay 1.5 km to 3.0 km for limitations and/or additional regulations that may apply to this use.
Subdivision Regulations
Subdivision must comply with Table 8.4(B).
Table 8.4(B) Subdivision Regulations
Subsection |
Regulation |
Measurement |
(a) |
Minimum lot width |
30.0 m |
Development Regulations
Development must comply with Table 8.4(C).
Table 8.4(C) Development Regulations
Subsection |
Regulation |
Measurement |
Height |
||
(a) |
Maximum height |
40.0 m |
Minimum setbacks |
||
(b) |
From a front lot line |
7.5 m |
(c) |
From a side lot line |
6.0 m |
(d) |
From a rear lot line |
6.0 m |
(e) |
From a rear lot line that abuts a lot with residential zoning |
7.5 m |
Floor area ratio |
||
(f) |
Maximum floor area ratio |
2.0 |