Strathcona County - Interactive Land Use Bylaw
Part 9 : Industrial Zones
9.5 IM – Medium Industrial
Purpose
To provide for industrial uses in accordance with the Heartland Industrial Area Structure Plan, some of which may generate nuisance and risk. Any nuisance or risk generated by a use should not extend beyond the boundaries of the site. This zone also allows for some compatible non-industrial uses and is not located adjacent to residential areas.
Uses
Subject to any fundamental use criteria for certain uses set out below, the permitted uses and the discretionary uses for this zone are listed in Table 9.5(A).
Table 9.5(A) Permitted and Discretionary Uses
* Refer to Part 6: Specific Use Regulations for additional regulations pertaining to this use.
^ Refer to Section 13.2 IHO 1.5 – Heavy Industrial Transition Overlay 0 km to 1.5 km and Section 13.3 IHO 3.0 – Heavy Industrial Transition Overlay 1.5 km to 3.0 km for limitations and/or additional regulations that may apply to this use.
Fundamental Use Criteria
The following uses shall only be considered in this zone if they meet the associated criteria below:
- (a) Asphalt plant minor, concrete plant major, concrete plant minor and general industrial uses shall not generate any nuisance beyond the boundaries of the site.
Subdivision Regulations
Subdivision must comply with Table 9.5(B).
Table 9.5(B) Subdivision Regulations
Subsection |
Regulation |
Measurement |
(a) |
Minimum lot width |
20.0 m |
Development Regulations
Development must comply with Table 9.5(C).
Table 9.5(C) Development Regulations
Subsection |
Regulation |
Measurement |
Height |
||
(a) |
Maximum height |
18.0 m |
Minimum setbacks |
||
(b) |
From a front lot line |
6.0 m |
(c) |
From a side lot line |
6.0 m |
(d) |
From a rear lot line |
6.0 m |
(e) |
Despite (c) and (d), a development officer may reduce the minimum setback from a side lot line or a rear lot line where the site is serviced by rail. |
|
(f) |
Maximum floor area ratio |
2.0 |